Purpose

This document describes how to update a sensor on a remote network .

Introduction

How do you update a sensor after it's been deployed to a remote network and the only method of accessing/administering the sensor is via one or more of the Reverse SSH connectivity methods?

Updating a Sensor On a Remote Network

After having established connectivity from a system acting as the SSH Receiver with the sensor, become superuser, then run the px-system-update command/script as follows:

  1. Using SSH, login to the sensor with the pwnie user account.
  2. Next, type sudo su and press Enter, then retype the password to become superuser.

    $ sudo su
    BASH
  3. Next, type px-system-update and press Enter to update the sensor.

    # px-system-update
    BASH




Copyright

© 2022 Outpost24® All rights reserved. This document may only be redistributed unedited and unaltered. This document may be cited and referenced only if clearly crediting Outpost24® and this document as the source. Any other reproduction and redistribution in print or electronically is strictly prohibited without explicit permission.

Trademark

Outpost24® and OUTSCAN™ are trademarks of Outpost24® in Sweden and other countries.