Knowledge base Vulnerability Management (Netsec) OUTSCAN/HIAB Netsec Agents Current: Setting Up an Agent Using System Proxy Setting Up an Agent Using System Proxy PurposeThis document describes how to set up an agent behind a proxy.Introduction LinuxUpdate the config files as below: // /etc/yum.conf proxy=http://<PROXY_IP>:<PROXY_PORT> // /etc/sysconfig/o24-agent HTTPS_PROXY="http://<PROXY_IP>:<PROXY_PORT>" Download and install o24-agent.WindowsIn the Start menu:Open Settings.Go to About.Click on Advanced System Settings.Click on Environment Variables.Under System Variables click New.Under New System Variable, fill in the new Variable Name and Variable Value.Click OK to add each new variable. Note To set up an Data Sovereign Agent using a system proxy, see Data Sovereign Agents - Deployment. Copyright© 2022 Outpost24® All rights reserved. This document may only be redistributed unedited and unaltered. This document may be cited and referenced only if clearly crediting Outpost24® and this document as the source. Any other reproduction and redistribution in print or electronically is strictly prohibited without explicit permission. TrademarkOutpost24® and OUTSCAN™ are trademarks of Outpost24® in Sweden and other countries. ×