Purpose

This document describes how to set up a HIAB as an Appsec Scale Scanner.

Introduction

Appsec Scale scans cannot run on the scheduler. A HIAB needs to be set up as an Appsec Scale scanner. 

To Set Up a HIAB as an Appsec Scale Scanner

Requirement

The internal Appsec Scale setup requires at least two appliances, one scheduler and one Appsec Scale scanner.

Set Up

To add scans in HIAB Appsec Scale, one of the Normal HIAB scanners must be turned to Appsec Scale scanner.

Note

Normal is a Scanner type.

  1. Go to Main Menu > Settings > Distribution.
  2. Right click the scanner you want to turn into an Appsec Scale scanner and select Set as Appsec Scale Scanner in the menu.

    Netsec - Set as Appsec Scale Scanner
    Appsec - Set as Appsec Scale Scanner i





Copyright

© 2021 Outpost24® All rights reserved. This document may only be redistributed unedited and unaltered. This document may be cited and referenced only if clearly crediting Outpost24® and this document as the source. Any other reproduction and redistribution in print or electronically is strictly prohibited without explicit permission.

Trademark

Outpost24® and OUTSCAN™ are trademarks of Outpost24® in Sweden and other countries.